Mount the IP Gateway in its desired location, away from any objects that might obstruct the radio signal or reduce its range. The unit can be DIN rail mounted using the clips on the base of the case.

If mounting in a control panel, make sure the panel box is plastic so that the radio signal can travel through it. If mounting in a metal box the aerial must be removed and connected outside the panel with a 50ohm coax lead. Please note that the connector type is RP SMA (reverse polarity).


Do not over-tighten the aerial as it may cause damage.


Always use the approved aerial provided with the unit. Fitting a more powerful aerial will cause the IP Gateway signals to travel further than designed. This will invalidate the warranty and may be contrary to the radio licence in your country.


Connect the IP Gateway to the Ethernet using a CAT5e or CAT6 cable and connect the IP Gateway to a 100mA, 24V dc power supply.