Installation of the Mini Series Door and Window Sensor can be done using the adhesive pads or screws provided.



NOTE: The Mini Series Door and Window Sensor and the magnet should be no further than 5mm apart.


Adhesive Pads Installation


  1. Ensure the surface is clean and dry. Use the included alcohol wipe to prepare the surface if required.

  2. Stick the included self-adhesive pads to the bottom of the Mini Series Door and Window Sensor and magnet.

  3. Peel off  the self-adhesive pads protective film.

  4. Stick the Mini Series Door and Window Sensor close to the edge of the door or window frame without hanging over. Ensure the solar panel gets as much light as        possible.

  5. Attach the magnet to the moving part of the door or window.


Installation Using Screws


  1. Remove the screw from the side of the unit and lift the Mini Series Door and Window Sensor from its backplate.

  2. Using the screws provided screw the Mini Series Door and Window Sensor back plate close to the edge of the door or window frame without hanging over. Ensure the solar panel gets as much light as possible.

  3. Place the Mini Series Door and Window Sensor onto the backplate.

  4. Replace the screw into the side of the unit and securely tighten.

  5. Attach the magnet to the moving part of the door or window.