Place the Mini Series Temperature and Humidity Sensor in an area of average room temperature keeping away from radiators, windows, ventilation units, cooling systems and any excess air movement. Ensure the solar panel gets as much light as possible.



NOTE: Installing the Mini Series Temperature and Humidity Sensor on the inside of an outside wall or directly over pipe work concealed in walls may negatively impact temperature measurement.


Once you have identified your desired surface installation of the Mini Series Temperature and Humidity Sensor can be done using the adhesive pads or screws provided.


Adhesive Pads Installation

  1. Ensure the surface is clean and dry. Use the included alcohol wipe to prepare the surface if required.

  2. Stick the included self-adhesive pads to the bottom of the Mini Series Temperature and Humidity Sensor.

  3. Peel off the self-adhesive pads protection film.

  4. Carefully stick the Mini Series Temperature and Humidity Sensor to the desired surface.


Installation Using Screws

  1. Remove the screw from the side of the unit and lift the Mini Series Temperature and Humidity Sensor from its backplate.

  2. Using the screws provided screw the Mini Series Temperature and Humidity Sensor back plate to the desired surface.

  3. Place the Mini Series Temperature and Humidity Sensor onto the backplate.

  4. Replace the screw into the side of the unit and securely tighten.