Pressac EnOcean CT Clamp

V2 Single Channel CT Clamp

The Pressac Sensing Wireless Single Channel CT Clamp is designed to measure and report the AC current flowing in a single conductor. Powered from the measured conductor itself, the measured current value is reported every 10 seconds (or every 30 seconds if the current is found to be below 3A) using the industry standard, wireless EnOcean® protocol. Available in a 60A, 200Amp and 600Amp versions (50Hz or 60Hz), the Pressac Sensing Wireless Single channel CT Clamp is easily installed with no disturbance to the measured conductor.

  • Energy harvesting – powered from the measured cable
  • Wireless communications – low installation costs, no networking required
  • Rapid and de-skilled installation – straightforward and easy set-up with no disruption
  • No batteries to replace – no maintenance costs

Appliance fingerprinting
Appliance Fingerprinting

Calculate the operational costs of each appliance

No batteries
No Batteries

Requires no batteries or wiring

Measure current
Measure Current

Transmits electrical current value (Amperes) wirelessly

Wireless
EnOcean compliant

Wide compatibility with other EnOcean® products.

V2 Single Channel Wireless CT Clamp Technical Data
Measurement Range 1A-60A ; 2A-200A ; 2A-600A
Measurement Frequency 50 or 60Hz
Accuracy +/- 1% FSD
Transmission Rate 30 Seconds
Reported Value Channel 1 in Amps
Repeater No
Environment Indoor
Enclosure Material Nylon 66
Sample Time Instantaneous
Telegram VLD
Calibration Not Required
Operating Temperature
& Humidity range
-5°C to +40°C; 85% RH
Storage Temperature & Humidity Range -20°C to +55°C; 85% RH
Diameter of Measurable Conductor 60A - 10mm
200A - 24mm
600A - 36mm
Dimensions of Clamp approx 60A - 25mm x 22mm x 35mm
200A - 35mm x 45mm x 65mm
600A - 65mm x 41mm x 85mm
Dimensions of Case approx 42mm x 62mm x 16mm
EEP D2-32-00